BDS 3" Strut Spacer Lift Kit for 2010-2018 Toyota 4Runner 4WD & 2007-2014 FJ Cruiser 4WD
- Important Kit Notes
- Vehicle Fitment Data
- Base Kit Components
- Manufacturer's Warranty Statement
Note: Components displayed in images may change based upon selections.
1. Strut compressor required for installation.
2. Other equivalent tire/wheel size options should work
3. May require minor trimming for some combinations.
4. Will not work on TRD Pro models equipped with the X-REAS shock system
5. Will not work with factory KDSS sway bar system
Front (Base Kit): 3 in Upper Strut Mount
Rear (Base Kit): 2 in Coil Spring
Tire and Wheel Combinations
FJ Cruiser with 285/75 R16 and Stock backspacing
4Runner with 275/60R20 and Stock/4.75" backspacing
4Runner with 285/70R17 and 17 x 8 w/ 5" backspacing
*Trimming may be required*
|Toyota||4 Runner 4WD||2010-2018|
|Toyota||FJ Cruiser 4WD||2007-2014\|
Estimated Installation Time (hours): 5
PDF (click here)
|(1)||018300||Fj Cruiser 3 In Box Kit|
|(1)||038209||Rear Fj Coil Spring|
|(2)||85879||NX² Shock Absorber|
*Subject to change based upon selections
No Fine Print Warranty
BDS stands behind its products and that’s evident by their No Fine Print Warranty. This no-BS warranty protects the original purchaser against breakage, bending, sagging, or any other usage failure. This “no fine print” lifetime replacement warranty extends to cover all BDS hard parts as well as bushings. Exclusions would be product finish and wearable items such as shock/stabilizer cylinders, tie rod ends and ball joints that would fall under the separate Limited Lifetime Warranty policy. Beginning February 1, 2020 all new kit purchases include the No Fine Print Warranty on bushings.
Limited Lifetime Warranty (for wearable items)
Wearable items include shock/steering stabilizer cylinders, ball joints and tie rod ends. BDS Suspension Co. warrants to the original retail purchaser that its these wearable parts are free from defects in material and workmanship for so long as they own the vehicle. Excluded from this warranty are the finish of the product. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable.