BDS 2.5" Lift Kit for 2000-2006 Toyota Tundra 4WD

BDS Suspension 2-1/2" lift kit for the 2000 - 2006 Toyota Tundra Pickup.
This 2-1/2" leveling kit comes with new upper strut mounts that add pre-load as well as a top spacer all in one piece.
The rear is lifted with a 1" block that bolts directly to your leaf pack or an optional 2" rear kit is available so you can customize the stance of your truck. Options also include a differential drop kit for this Toyota Tundra 2-1/2" lift kit.

Note: Components displayed in images may change based upon selections.

1. Strut compressor required for installation.
2. If you desire to maintain the factory stance of your vehicle, select the 2" rear block & u-bolt kit in the Related Accessories section below.

Lift Height
Front (Base Kit): 2.5 in Upper Strut Mount
Rear (Base Kit): 1 in Block

Tire and Wheel Combinations
32 x 11.50 with - and 5" backspacing
*Trimming may be required* 

Difficulty Level (1 easy – 5 complicated): 3
Estimated Installation Time (hours): 6

Instructions
PDF (click here)

*Subject to change based upon selections

No Fine Print Warranty
BDS stands behind its products and that’s evident by their No Fine Print Warranty. This no-BS warranty protects the original purchaser against breakage, bending, sagging, or any other usage failure. This “no fine print” lifetime replacement warranty extends to cover all BDS hard parts as well as bushings. Exclusions would be product finish and wearable items such as shock/stabilizer cylinders, tie rod ends and ball joints that would fall under the separate Limited Lifetime Warranty policy. Beginning February 1, 2020 all new kit purchases include the No Fine Print Warranty on bushings.

Limited Lifetime Warranty (for wearable items)
Wearable items include shock/steering stabilizer cylinders, ball joints and tie rod ends. BDS Suspension Co. warrants to the original retail purchaser that its these wearable parts are free from defects in material and workmanship for so long as they own the vehicle. Excluded from this warranty are the finish of the product. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable.