BDS 6" Suspension Lift Kit for 2003-2007 Dodge/Ram 2500 & 3500 Pickup

BDS Suspension 6" Lift Kit for the 2003 - 2007 Dodge Ram 2500 3/4 Ton and 1 Ton 4WD Pickup - Gas & Diesel.
This 6" lift kit includes front Pro-Ride Coil Springs and heavy duty, tubular, upper and lower control arms. The lower arms are longer than stock to rotate the axle for proper alignment. A relocation bracket is used to flatten out the angle of the upper control arm to maintain your factory handling characteristics. All four control arms are greasable for long term performance.
A dropped forged pitman arm is included to maintain the factory steering angles. A track bar relocation bracket properly centers the axle under the vehicle. Extended bump stops and sway bar links maintain the OE characteristics.
The rear of the Dodge Ram is lifted via a 4" block kit or optional Glide-Ride Leaf Springs. Not only is the kit designed to last, but so is the finish. Every bracket is powder coated twice with a base grey color and then a clear coat over the top to ensure long term performance of our finish.

Note: Components displayed in images may change based upon selections.

1. This truck is available with two different axle sizes, 3.5" or 4". Measure rear axle tube before ordering. Some 4" axle models with dual overloads will require u-bolt 4068.
2. Will not fit dually applications.
3. Although unusual, if driveline vibration occurs, order transfer case drop kit available in options or t-case index kit. #122801 is included in 8" kits, substitute #122802 for manual transmission.
4. Optional transfer case drop kits fit automatic transmission models only.
5. Exhaust modification will be required for dual rear shock kit 122009 on 6.7L Diesel models.
6. Coil springs are specifically designed for each vehicle. Please select engine type so we can get you the appropriate custom rated coil springs.

Lift Height
Front (Base Kit:) 6 in Pro-Ride Coil Springs
Rear (Base Kit:) 4 in Block Kit

Tire and Wheel Combinations
36" x 12.50" with 17 x 9 and 5" backspacing
*Trimming may be required*

Difficulty Level (1 easy – 5 complicated): 3
Estimated Installation Time (hours): 6-8

Instructions
PDF (click here)

*Subject to change based upon selections

No Fine Print Warranty
BDS stands behind its products and that’s evident by their No Fine Print Warranty. This no-BS warranty protects the original purchaser against breakage, bending, sagging, or any other usage failure. This “no fine print” lifetime replacement warranty extends to cover all BDS hard parts as well as bushings. Exclusions would be product finish and wearable items such as shock/stabilizer cylinders, tie rod ends and ball joints that would fall under the separate Limited Lifetime Warranty policy. Beginning February 1, 2020 all new kit purchases include the No Fine Print Warranty on bushings.

Limited Lifetime Warranty (for wearable items)
Wearable items include shock/steering stabilizer cylinders, ball joints and tie rod ends. BDS Suspension Co. warrants to the original retail purchaser that its these wearable parts are free from defects in material and workmanship for so long as they own the vehicle. Excluded from this warranty are the finish of the product. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable.