BDS 2" Leveling Kit for 2007-2013 1/2 Ton Pickup 2WD & 4WD Silverado/Sierra, 2007-2013 Avalanche 1500 4WD, 2015-2019 Suburban 1/2 Ton 4WD
- Important Kit Notes
- Vehicle Fitment Data
- Base Kit Components
- Manufacturer's Warranty Statement
BDS Suspension 2" Leveling Kit for 2007-2016 Chevrolet/GMC 4WD 1/2 ton Suburban, Avalanche, Tahoe, Yukon, Yukon XL, and 2007-2014 Sierra/Silverado1500 pickup trucks.
This kit is designed to eliminate the factory nose-low rake while improving the vehicles all-around performance and allowing room for larger tires. The kit integrates a new top mounted strut spacer in combination with a pre-load spacer to raise the front end while improving the handling and stability. This 2-piece leveling kit design allows the suspension to fully cycle through wheel travel without maxing out the upper ball joints at full drop as is the case with taller 1-piece strut spacer kits on the market.
Note: Components displayed in images may change based upon selections.
1. Will NOT work on Auto Ride or Magneride equipped models
2. Strut compressor required for installation
3. This system will not fit 2007 classic models
4. Will NOT fit 2014 Model 1/2 Ton Pickup models
Front (Base Kit): 2 in Strut Mount
Rear (Base Kit): N/A
Tire and Wheel Combinations
285-70 R17 with stock wheel and stock backspacing
*Trimming may be required*
Difficulty Level (1 easy – 5 complicated): 3
Estimated Installation Time (hours): 3
PDF (click here)
|(1)||021202||07-17 Chevy/GM 1500 2in Leveling Kit|
*Subject to change based upon selections
No Fine Print Warranty
BDS stands behind its products and that’s evident by their No Fine Print Warranty. This no-BS warranty protects the original purchaser against breakage, bending, sagging, or any other usage failure. This “no fine print” lifetime replacement warranty extends to cover all BDS hard parts as well as bushings. Exclusions would be product finish and wearable items such as shock/stabilizer cylinders, tie rod ends and ball joints that would fall under the separate Limited Lifetime Warranty policy. Beginning February 1, 2020 all new kit purchases include the No Fine Print Warranty on bushings.
Limited Lifetime Warranty (for wearable items)
Wearable items include shock/steering stabilizer cylinders, ball joints and tie rod ends. BDS Suspension Co. warrants to the original retail purchaser that its these wearable parts are free from defects in material and workmanship for so long as they own the vehicle. Excluded from this warranty are the finish of the product. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable.