• BDS 2" Leveling Kit
BDS1436H

BDS 2" Leveling Kit for 2020 Jeep Gladiator

  • $512.45

These 2" leveling kits are a step up from the competition, offering better on-road and off-road performance with room for 35" tires. These systems replace the factory coil springs with full length ProRide coil springs to provide 2" of lift up front to level the stance, improved wheel travel and allow full coil bind. Ride quality is enhanced with your choice of specially tuned NX2 gas series or FOX 2.0 performance series IFP shocks (coming soon) at each corner offering split second response to changes in the terrain with velocity sensitive valving. In additional to coil springs and shocks, these 2" leveling kits include front bump stop extensions to properly limit up travel of the suspension. To further improve on the factory suspension, these kits replace the factory sway bar links with (JKS) quicker disconnects to correct the sway bar operating angle while allowing you to easily disconnect the front sway bar to improved articulation offroad. The disconnects include mounting post hardware as well as retaining posts to hol the sway bar up out of the way when disconnected.
As with all BDS Suspension products these are backed by Factory Protection Plus offering safety and security with the No Fine Print Warranty and ESC system compatibility along with 5-year, 100,000-mile extended drivetrain warranty. Take your new 2020 Jeep Gladiator JT to the next level with BDS Suspension.

Note: Components displayed in images may change based upon selections.

Lift Height
Front (Base Kit): 2 in Coil
Rear (Base Kit): N/A

Tire and Wheel Combinations
35 x 12.50 with 17x9/18x9/20x9 and 4.5-5 backspacing
*Trimming may be required* 

Make Model Lift Year Range
Jeep Gladiator 2" 2020

Difficulty Level (1 easy – 5 complicated): 2
Estimated Installation Time (hours): 2-3

Instructions
PDF (click here)

Qty Part# Description
(1) 014231 JT 2" Leveling Kit
(2) 85719 NX² Shock Absorber
(2) 85782 Shock - 26.2 x 15.67 x 2-3/8 - EB1/EB1

*Subject to change based upon selections

No Fine Print Warranty
BDS stands behind its products and that’s evident by their No Fine Print Warranty. This no-BS warranty protects the original purchaser against breakage, bending, sagging, or any other usage failure. This “no fine print” lifetime replacement warranty extends to cover all BDS hard parts as well as bushings. Exclusions would be product finish and wearable items such as shock/stabilizer cylinders, tie rod ends and ball joints that would fall under the separate Limited Lifetime Warranty policy. Beginning February 1, 2020 all new kit purchases include the No Fine Print Warranty on bushings.

Limited Lifetime Warranty (for wearable items)
Wearable items include shock/steering stabilizer cylinders, ball joints and tie rod ends. BDS Suspension Co. warrants to the original retail purchaser that its these wearable parts are free from defects in material and workmanship for so long as they own the vehicle. Excluded from this warranty are the finish of the product. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable.