BDS Suspension 2" Lift Kit for 2007-2017 Jeep Wrangler JK 2 Door 4WD - Standard Jeep or Rubicon
- Important Kit Notes
- Vehicle Fitment Data
- Base Kit Components
- Manufacturer's Warranty Statement
This 2" lift kit comes with four new urethane coil mounts, bump stop extensions, front octo-cam washers, JK exhaust kit, front swaybar links and NX² series shock absorbers.
BDS carries a large selection of accessories for Jeep JK's so check out what is available for this 2" lift by customizing your system.
Note: Components displayed in images may change based upon selections.
1. Removing the OE spring isolators will result in a 1" lift if desired.
2. 124408 rear track bar or 124308 rear track bar relocation is recommended if using factory wheels
3. This kit is FMVSS No.126 Compliant
The NHTSA's Federal Motor Vehicle Safety Standard (FMVSS) No.126 requires all new passenger vehicles to include Electronic Stability Control (ESC) systems that meet certain standards that can be tested through a comprehensive series of evasive maneuvers. Aftermarket products must meet these standards as well. BDS Suspension is leading the industry by independently testing all suspension kits to verify our kits are fully compliant with the stability control system requirements set by Federal Motor Vehicle Safety Standard (FMVSS) No. 126.
Front (Base Kit): 2 in Coil Spacer
Rear (Base Kit): 2 in Coil Spacer
Tire and Wheel Combinations
33" x 12.50" with 17 x 9 and 4-1/2" backspacing
*Trimming may be required*
|Jeep||Wrangler||JK 2 Door||2"||Front & Rear||2012-2018|
Difficulty Level (1 easy – 5 complicated): 2
Estimated Installation Time (hours): 4
PDF (click here)
|(1)||024203||JK 2 In Urethane Coil Mount Kit|
|(1)||124314||12-18 Jeep JK Exhaust Extension Kit|
|(1)||124320||JK Front Sway Bar Links|
|(2)||85700||BDS NX2 Shock Absorber|
|(2)||85951||NX² Shock Absorber|
*Subject to change based upon selections
No Fine Print Warranty
BDS stands behind its products and that’s evident by their No Fine Print Warranty. This no-BS warranty protects the original purchaser against breakage, bending, sagging, or any other usage failure. This “no fine print” lifetime replacement warranty extends to cover all BDS hard parts as well as bushings. Exclusions would be product finish and wearable items such as shock/stabilizer cylinders, tie rod ends and ball joints that would fall under the separate Limited Lifetime Warranty policy. Beginning February 1, 2020 all new kit purchases include the No Fine Print Warranty on bushings.
Limited Lifetime Warranty (for wearable items)
Wearable items include shock/steering stabilizer cylinders, ball joints and tie rod ends. BDS Suspension Co. warrants to the original retail purchaser that its these wearable parts are free from defects in material and workmanship for so long as they own the vehicle. Excluded from this warranty are the finish of the product. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable.