• BDS 2" Coil Spacer Lift Kit
BDS1401H

BDS Suspension 2" Lift Kit for 2007-2011 Jeep Wrangler JK 2 Door 4WD - Standard Jeep or Rubicon

  • $384.94

This 2" lift kit comes with four new urethane coil mounts, bump stop extensions, front octo-cam washers, front sway bar links and NX² series shock absorbers.
BDS carries a large selection of accessories for Jeep JK's so check out what is available for this 2" lift by customizing your system.

Note: Components displayed in images may change based upon selections.

1. Removing the OE spring isolaters will result in a 1" lift if desired.
2. 124408 rear track bar or 124308 rear track bar relocation is recommended if using factory wheels
3. This kit is FMVSS No.126 Compliant

The NHTSA's Federal Motor Vehicle Safety Standard (FMVSS) No.126 requires all new passenger vehicles to include Electronic Stability Control (ESC) systems that meet certain standards that can be tested through a comprehensive series of evasive maneuvers. Aftermarket products must meet these standards as well. BDS Suspension is leading the industry by independently testing all suspension kits to verify our kits are fully compliant with the stability control system requirements set by Federal Motor Vehicle Safety Standard (FMVSS) No. 126.

Lift Height
Front (Base Kit): 2 in Coil Spacers
Rear (Base Kit): 2 in Coil Spacers

Tire and Wheel Combinations
33" x 12.50" with 16 x 8 and 4-1/2" backspacing
*Trimming may be required* 

Make Model Type Lift Location Year Range
Jeep Wrangler JK 2 Door 2" Front & Rear 2007-2011

Difficulty Level (1 easy – 5 complicated): 2
Estimated Installation Time (hours): 4

Instructions
PDF (click here)

Qty Part# Description
(1) 024203 JK 2 In Urethane Coil Mount Kit
(1) 124320 JK Front Sway Bar Links
(2) 85700 BDS NX2 Shock Absorber
(2) 85951 NX² Shock Absorber

*Subject to change based upon selections

No Fine Print Warranty
BDS stands behind its products and that’s evident by their No Fine Print Warranty. This no-BS warranty protects the original purchaser against breakage, bending, sagging, or any other usage failure. This “no fine print” lifetime replacement warranty extends to cover all BDS hard parts as well as bushings. Exclusions would be product finish and wearable items such as shock/stabilizer cylinders, tie rod ends and ball joints that would fall under the separate Limited Lifetime Warranty policy. Beginning February 1, 2020 all new kit purchases include the No Fine Print Warranty on bushings.

Limited Lifetime Warranty (for wearable items)
Wearable items include shock/steering stabilizer cylinders, ball joints and tie rod ends. BDS Suspension Co. warrants to the original retail purchaser that its these wearable parts are free from defects in material and workmanship for so long as they own the vehicle. Excluded from this warranty are the finish of the product. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable.